Hello again, Martin here. The outside temperatures may be unseasonably warm, but that’s not going to defer the holiday entertaining schedule that’s about to get real. My family, my girlfriend’s family, and my friends and neighbors are big into get-togethers during Thanksgiving, Christmas, and New Year’s, which translates into lots of great feasts and lots of amazing wines and spirits. This time of year, wine is the perfect hostess and holiday gift. But with all of those brand new shiny bottles collecting on your countertops as your guests bring them in; it’d be nice to have extra storage that also let you show them off. Well, have I got a project for you. Not only is this PVC wine rack a perfect gift idea, if you’re an entertainer who likes to serve wine, it’s one of those projects you’ll want to make and keep for yourself.
This is wine rack is so easy to make, here’s all you need to do:
Gather these materials:
First, if I don’t have all of the materials I need, I head out to my local building supply store. You can buy Inteplast Building Products PVC trim at your local Home Depot, or you can check out this retail locator from Inteplast Building Products to find a retailer in your area.
Next, I make four marks, every 10” on the 1 x 4 PVC trim board. Then, on the table saw, I make miter cuts (45 degrees) at every 10” mark.
Once I have the four pieces cut of the PVC trim cut, which will become the wine bottle holders, I roughly line them up to make sure they fit together. This also helps me determine the size of the backer board. Now, I’ll cut the 1 x 10 PVC trim board to 29” long and 9-1/2” wide.
All of my pieces are cut and ready for assembly. I’ll first mark where the bottle holes will be drilled. Starting 2” from the end, I’ll mark the center for the first hole, and then from the center of the first hole, I’ll measure over 3-3/4” for the center of the second hole. I’ll need to repeat this for each of the other three pieces. Check out the diagram at the end of this post for more detail.
Next, apply PVC cement on the edges of each bottle holder, and press them in place on the backer trim board.
After you’ve applied the PVC cement, wait about 3 minutes until it’s dry, and then flip it over and permanently attach with 1-1/2” screws, starting at the edge. Apply three screws for each PVC bottle holder trim piece. Start from the sides and use a straight edge as a guide for the middle screws.
Now you’re ready to hang it on the wall. Using a stud finder, locate the stud. Mount the rack with a screw on the top and one on the bottom, 1” from each edge. Make sure you are going into a stud, you don’t want your wine collection to end up on the floor!
That’s it! Your finished project can hold up to 8 bottles of wine.
Once you’ve got all of your materials and tools gathered, this project shouldn’t take you more than an hour or two tops! Hope you make out ok with the project, and as always, I’m ready to talk shop, so let me know what projects you’re working on. Thanks for reading.
Martin (and Harley)